What to Do If Your Circuit Breaker Trips

Your home's circuits may be overloaded with too many appliances. If you have several high-wattage devices plugged into one outlet (such as a washing machine, dryer, and refrigerator), consider relocating them to another circuit or installing a subpanel for more circuits.

If you have an older home with knob-and-tube wiring (uncommon but still found in older homes), this electrical system can only handle 15 amps per circuit. If you have several high-wattage appliances on one circuit, they will overload it and cause it to trip.

You may be trying to use an extension cord on an overloaded outlet or a faulty outlet that's not grounded properly (the ground wire is missing). Have an electrician check your wiring if this is often happening.

Light fixtures and lamps draw more current than outlets, so if too many are on a single circuit breaker, they may overload and trip the breaker (or blow fuses). If you have more lights than outlets in your home, consider adding another light switch and outlet so they can be on separate circuits.

Incorrectly wired switches. Switches are at risk of short circuits if they are not wired correctly. If a switch is installed with a neutral wire but no hot wire, it can cause a fault in the breaker.

Turn off affected items. If the breaker tripped because of overloaded circuits, your appliances were drawing too much electricity through those circuits. Therefore, unplug everything from those outlets until you figure out what's happening with them. 

Do you know where your circuit breakers are? Often circuit breakers are in the basement. In apartment houses, each apartment may have panels within its apartments. There is no standard place to find them, but they are often evident and typical gray boxes with a door. In some homes, there may be multiple circuit breaker boxes, one for each floor, another for an emergency generator, etc. 

Find the circuit breakers that tripped. The circuit breakers will be marked with their location in an ideal situation. Often inside the panel door is a chart identifying the bathroom, 1st-floor bedroom, kitchen, etc. Sadly, this step is sometimes skipped, and you are left trying to figure it out. 

However, when a circuit trips, the switch for that circuit will trip into the opposite position as every other circuit in the box, or it will be in the middle. If you cannot visually tell, slide your fingers over each circuit and feel which one is not like the others. Once you identify the tripped circuit - flip the switch back on. 

Turn everything back on. Once the circuit is back on, you can start turning your electronics, lights, and appliances back on. If you forget to shut them all off first, the circuit may trip again from the immediate rush of power. 

Repeated Circuit Breaker Tripping

Have you ever had a circuit repeatedly trip? In those cases, you may need more circuits added to the panel or perhaps even another panel. A good example is that you cannot run the microwave while running the air conditioner. If you do, it is guaranteed the power will trip the circuit. The solution should not be to remember to shut the air off if you are running the microwave. The solution should be to adjust the circuits - by adding circuits, circuit breaker replacement, splitting the load, adding a panel, and more. In either event, a qualified electrician from Mr. Electric knows which solution is best for your home.